My connection was working fine until I configured a xbox, now I cannot connect any computers to the same network. I connected my at&t cable directly and it works just fine. Now I cannot connect anyÂ devicesÂ to the 2wire wireless network. I am planning to re configure at&t 2wire again but I cannot access the default page because of incorrect password. is there any default Password for this?
Answer: at&t 2wire default password (â€œwirelessâ€) remains same as 2wire 2701hg-b and 2wire modem.
Make sure you are using this password as â€œwirelessâ€ or â€œadminâ€ to access the settings page. This pages helps you controlling router features like enabling the ports, setup security WEP/WPA, and other internet helpful settings.
If you are unable to connect to 2wire wifi network may be you are entering the WEP or WPA password incorrect. Router prompts for this password only if you have setup wifi security during the installation.2wire default wifi password can be reset by accessing its router settings page.
2wire router Installation:
All new 2wire router comes along with installation disc, Once you connectÂ cables you just have insert disc and follow installation wizard which completes the installation process.
In 2wire router by default DHCP will be enabled, so you don’t have to make any changes on DHCP settings, This feature is used to assign dynamic IP addresses to the computers. DHCP is an acronym for Dynamic Host Configuration Protocol.
If anyone is facing this problem feel free to ask questions using the comment section below.